Polk Audio PSWi225 Bedienungsanleitung PDF herunterladen (Seite 4)

AC POWER CONNECTION AND AUTO ON/OFF

Off/Auto/On Switch

Your PSWi225 Subwoofer uses a 3-position power switch, which

selects your subwoofer’s operational mode. The three modes are:

Off, Auto and On.

Off

With the switch in this position, the subwoofer is inactive.

Auto

In the “Auto” position, your subwoofer automatically turns on when it senses

an audio signal and the LED located on the back of the subwoofer will turn green.

We recommend the “Auto” mode if your subwoofer is always receiving

power (i.e., if it’s plugged into a wall outlet). When no signal is present, the

subwoofer will enter a “waiting” state after 15 minutes and the LED will turn red.

The subwoofer is always on and fully active in this mode. The LED on the back

of the subwoofer will be green. This mode is best if the subwoofer is plugged

into a switched power outlet.

Note: You may want to leave your subwoofer unplugged during extended

periods of non use, such as during a vacation.

CONNECTING THE SUBWOOFER TO

THE SYSTEM—HOOKUP OPTIONS

IMPORTANT NOTE: USE ONLY ONE OF THESE OPTIONS.

NEVER COMBINE HOOKUP OPTIONS.

OPTION #1 Receivers that include a “SUB OUT” feature—

the most common hookup method with Dolby Digital

and DTS

receivers.

• Connect a single RCA cable from the “SUB OUT” of your receiver

to the LFE input of the transmitter.

• Connect all other speakers directly to the receiver.

• Adjust your receiver’s speaker configurations as follows:

Front Speakers = SMALL

Center and Surrounds = SMALL

Subwoofer = ON, YES, or PRESENT

• Depending on your front speakers’ bass output capabilities, set the crossover

frequency on the receiver to 80Hz for tower and bookshelf speakers (speakers

with a woofer 5 1/4" in diameter or larger) and 100-120Hz for satellite speakers.

Consult your receiver’s owner’s manual for instructions.

WIRELESS TRANSMITTER

WIRELESS SUBWOOFER

SUB-OUT

RECEIVER

FRONT REARCENTER

DC 5V 1A

4 Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)

The two switches

must be set to the

same position for the

subwoofer to receive

a signal.

1 2 3 4 5 6 7 8 9 ... 26 27

Kommentare zu diesen Handbüchern

Keine Kommentare

Polk Audio PSWi225 Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Subwoofer Polk Audio PSWi225